Time to get that exhaust planned out and welded up! It’s 98% finally! I know the exhaust is still really close, but allot of heat shielding needs to be installed to make sure the shock doesn’t get cooked. I get allot of responses on how this setup will break the...
k here we go. Going to cut up that aluminium subframe I spend so much time on. It needs to be noticed out on the inside on both sides. The exhaust is going to run so extremely close to the rear shock that I need to create extra space, every mm...
In some time I will be making all the fairings out of carbon fiber. However I first need to make molts to allow that fabrication. To make sure everything is going to look exactly how I want, and to be able to make quick design changes I started designing all the...
Time to mount that sick Husqvarna headlight. I fabricated a super simple aluminium bracket that allows the headlight to also be mounted using rubber grommets. We are getting...
Another thing that still needed to be done were the lambda bungs in the exhaust. All done now! Allowing for tuning the engine later on, and measuring the lambda values for each cylinder...
Another small thing that needed to be managed was the fuel tank breather. Including a one way valve making sure the tank can suck in air. But in the meantime making sure no fuel fumes leak out into my living room haha. Custom 3D printed bracket out of high temperature...
