It took +/- 70 weld seams, 1500 liters of Argon and almost 8 months of spare time to get this done. This was a very large hurdle that took allot of learning and effort, but I must say I am pretty happy with the final result. To bad allot of it will be covered up by...
The fuel line routing is a bit different… Modified the injector caps to only feed from 1 side and then using T and 90 degree fittings to get everything routed. Mimicking the 848/1098 fuel line routing. All connected to the using a quick release fitting that seals the...
Fabricated a custom crankcase breather is made out of a aluminium storage canister. Milled out some slots, turned out a hole on the lathe for a bulkhead fitting and filled it with explosafe foam. Will be mounted somewhere in the rear below the seat like in the...
Designed and 3D printed a fuel line bracket to mount directly on the fuel pump. This will take the load of the plastic fittings since they are prone to leak when under tension so came up with this solution. Printed out of HTPLA with 10% Carbon fibers and then baked in...
Finally started fabricating the fuel tank (WARNING, allot of pictures haha)! When I started the project 3.5 years ago this one has been on my mind because of it being a massive challenge because of the limited space and complex shape. It has been a long run planning,...
