Another thing that still needed to be done were the lambda bungs in the exhaust. All done now! Allowing for tuning the engine later on, and measuring the lambda values for each cylinder...
Another small thing that needed to be managed was the fuel tank breather. Including a one way valve making sure the tank can suck in air. But in the meantime making sure no fuel fumes leak out into my living room haha. Custom 3D printed bracket out of high temperature...
This is a game changer for me! I designed 3D printed pie-cuts that allow me to plan out any exhaust run before actually welding. This reduces so much waste of exhaust runs that doesn’t look quite right, or allowing beforehand to check if a specific run is even...
The fuel tank still needed to be mounted to the frame. I had some aluminium brackets lasercut that I could weld to the frame. Those bracket allow the use of rubber grommets making sure the tank isn’t solidly mounted to the vibrating frame/engine. Also put the...
